![]() Thanks to Gil Obradors for contributing this feature! Software Updates: Optionally reboot after updating ![]() When adding a manual IPv4 address to a network interface, the dialog now fills in plausible values for the net mask (based on the network class) and gateway (usually ending with. Networking: Suggest netmask and gateway addresses The metrics page now displays the CPU temperature and includes a warning icon when the system becomes too hot. Here are the release notes from Cockpit 273 and cockpit-machines 272: Metrics: Display CPU temperature Once the installation is complete, you can use the application to search for the Psensor application and launch it.Cockpit is the modern Linux admin interface. ![]() Run the following command to install it: sudo apt install psensor ![]() Psensor is a graphical tool that relies on the lm_sensors program to display temperature readings in a graphical format. This will display the temperature of your CPU cores as shown below: $ sensors coretemp-isa-0000 When the configuration is done, check the CPU temperature by invoking the sensors command. Once installed, run the following command to configure lm_sensors: sudo sensors-detect If it is not installed already, you can install it as shown below: sudo apt install lm-sensors hddtemp Lm_sensors comes pre-installed with most modern Linux operating systems. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |